200 liter
Showing all 6 results
-
BPS 7726
BPS 7726 is a silane based facade protection for use on concrete and reinforced concrete. Consists of “small molecules” contributing to a deep penetration. BPS 7726 prevents the surface against water and salt ingress. Is permeable, i.e. water cannot penetrate, but the surface “can breathe” and release moisture. BPS 7726 is approved according to EN 1504-2, alone and in combination with AGS 3502 graffiti protective coating.
-
BPS 7102
BPS 7102 is an alkaline cleaner, used for cleaning of dirty surfaces. Mainly used outside. Dissolves soot, greasy residues. Biodegradable.
BPS 7102 can be used on most surfaces such as:- Plaster
- Limestone
- Concrete
- Alkaline bricks
- Wood
- Aluminium surfaces
- Granite
-
BPS 7111
BPS 7111 is used for removal of algae, mould, lichen or other fouling from most surfaces such as: brick, concrete, plaster, granite, lime and sandstone, roofing tiles and wood. Safe to use and gives no negative impact on building materials. BPS 7111 offers up to 10 years protection against algae or other fouling. Biodegradable.
NB! Hard surfaces with no porosity can not be treated. If rainfall appears within 24 hours, the effectiveness of the treatment will be affected. Make sure to apply during dry conditions.
-
AGS 560
AGS 560 is especially developed for removal of graffiti on plexiglass. Effectively removes marker felt-tip pen and rust protective coating without attacking the plexiglass. AGS 560 is also effective on other painted and delicate surfaces. AGS 560 even works on spray paint graffiti, but the dissolving time is a little bit longer. Testing on a small surface prior to removal is recommended. For outside and indoor use. Biodegradable.
-
AGS 2+ GEL
AGS 2+ GEL is a powerful graffiti and paint remover. For use on exterior and interior surfaces. AGS 2+ GEL may be used on porous surfaces for all weather conditions. AGS 2+ GEL effectively dissolves spray paint graffiti and permanent markers. Readily biodegradable according to OECD test 302 B.
AGS 2+ GEL may be used on following surfaces:
Porous surfaces
Concrete, brick, granite, marble, limestone, sandstone, slate, surfaces painted with non-organic paint.Hard surfaces
Metal, treated wood, clinker, glazed brick, glass. -
AGS 65
AGS 65 removes shadowing left in substrate following graffiti removal, in special cases also paint removal. AGS 65 is formulated for use on the following materials: granite, slate, sand-stone, glazed brick, treated marble, wood and non-organic paint. AGS 65 is slightly thickened to cling on surface and increase the dwelling time. Readily biodegradable. For use on exterior and interior surfaces. Primarily used on porous surfaces.
NOTE! AGS 65 must not be used on soft metal surfaces, aluminium, e.g.